Infrasonic BLOW5 Manuel d'utilisateur télécharger pdf (Page 11)

BLOW5/BLOW5D User’s Manual

4. CONNECTION

4.1. POWERING UP

IMPORTANT NOTE

 All connections should be made, And faders, volumes, sensitivity and other controls are at minimum levels.

 Before powering up the BLOW5 speakers, all other equipment should be turned on first.

 Please make sure that the unit is plugged into the correct voltage.

 The power switch is located on the rear panel.

 Turn on the power to the BLOW5.

 The unit is equipped with a protection circuit, an interval of a few seconds is required before the unit will

operate normally.

4.2. ANALOG AUDIO INPUT

 Connect the male side of an XLR balanced cable to the XLR input or TRS balanced (or unbalanced) cable

to the TRS input of the rear panel.

 Input Select Switch should be set to analog input.

 Refer to the following diagram.

< Connecting of Analog XLR balanced cable >

< Connecting of TRS Analog balanced/unbalanced cable >

RS balanced cable

RS unbalanced cable

balanced cable

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Infrasonic BLOW5 Manuel d'utilisateur Page 11